Isp-technologies CS 650 Manual do Utilizador Página 1

Technologies HDDSrM HDDS CS650 6.5" CEILING SPEAKER SPEAKER OWNERS MANUAL

Insert the CS650 into the ceiling tile hole and through the tile bridge opening. Begin to tighten the installation screws. As you start to turn

HDDS CS650 SPECIFICATIONS POWER CONSUMPTION: 400 mA typical 1.8 amps Maximum AUDIO INPUT:

WARRANTY AND SERVICE The unit, parts and workmanship are fully guaranteed to be free of defects under normal use and service for a pe

IMPORTANT SAFETY INSTRUCTIONS! Please read this very carefully before operating this unit  Read ALL instructions carefully before using this u

INTRODUCTION Thank you for your purchase of the ISP Technologies High Definition Distributed System CS650 Surface Mount Speaker. This product

OPERATION The HDDS Master Control Module is the Master control center for distributed sound systems using the HDDS technology.

Rear of Speaker The rear of the CS650 Speaker includes three RJ45 connectors one for input and one for output and one that allows

Connect the CS650 to any of the A,B or C outputs on the rear of the HDDS Master Control Module as shown below. Internal Loudness Circu

Connections to the CS650 Speaker The CS650 bottom edge of the Printed Circuit Board contains three RJ45 connectors, providing IN

speaker CS650. Each of the three outputs A, B and C are capable of delivering up to 7 amps of output current. With a typical power per speaker of 1

Speaker Installation The CS650 is designed to be used with the supplied tile bridge and backcan. CAUTION: Be certain that there